User manual

Operating instructions
16
Performing a Washing Cycle
Brief Instructions
A washing cycle is performed in the following steps:
0 1. Open the door, load the washing.
2. Close the door.
3. Add detergent/conditioner.
4. Set the correct washing program:
– Set the program on the program selector;
– Set the temperature on the temperature selector;
– In the case of easy-care washing: Press the } (EASY-CARES) but-
ton.
5. Press the M (ON/OFF) button.
The washing machine is switched on. The washing program starts.
6. If necessary, change the spin speed or select rinse hold.
You can alter this setting and the temperature during the entire
washing cycle.
At the end of the washing program:
Important! If the washing cycle ends with rinse hold, perform either
v (PUMP OUT), position 6 (SPIN), or position 8 or 11 (SHORT SPIN)
before opening the door.
3
For safety reasons, the door remains locked for 1-2 minutes after the
end of the program.
7. Open the door, remove the washing.
8. Press the M (ON/OFF) button.
The washing machine is switched off.