User manual

Instructions for use

Washing Cycle Ended/Remove Washing

After a washing program has ended, END (ENDE, FINE) lights up on the

program sequence display.

If you selected RINSE HOLD (SPÜLSTOPP, NO CENT. FINALE), the indica-

tor next to the button START/PAUSE flashes.

0 1. After a rinse hold, it is first necessary to pump off the water:

– Press either the button START/PAUSE (water is pumped off and the

washing is spun according to the program which has just run; after

pressing the button START/PAUSE again, the spin speed can also still

be changed during spinning),

– turn the program selector to OFF (AUS, OFF) and then to PUMP

(PUMPEN, SCARICO) and press the button START/PAUSE (water is

pumped off without spinning)

– turn the program selector to OFF (AUS, OFF) and then to SPIN

(SCHLEUDERN, CENTRIFUGA) or SHORT SPIN (SCHONSCHLEUDERN,

CENTRIFUGA DELIC.) and press the button START/ PAUSE (water is

pumped off and the washing is spun or gently spun).

After the end of this program step, the indicator END (ENDE, FINE)

lights up.

2. Open the filling door.

As soon as the indicator DOOR (TÜR, PORTA) lights up green, the filling

door can be opened.

3. Remove the washing.

4. Turn the program selector to OFF (AUS, OFF).

5. After washing, pull out the washing detergent drawer slightly so that it

can dry out. Only lean the door against the washing machine so that

the latter can air out.

If the display OVER DOSING (ÜBERDOSIERT, DOSE

ECCESSIVA) lights up, too much washing detergent

was used in the washing program just ended. During the next wash, pay

attention to the dosing information of the washing detergent

manufacturer and pay attention to the filling quantity!

Attention! If the washing machine is not used for a long time:

Close the water tap and disconnect the washing machine from the

electricity mains. (The Aqua Control water protection does not function

if the power supply is interrupted).