Washer User Manual

Installation and Connection Instructions

Power supply

Details on the mains voltage,

type of current and the neces-

sary fuse protection are to be

found on the rating plate. The

rating plate is above and

behind the door.

For permanent electrical con-

nection within the electrical

circuit, provisions must be made which allow for electrical disconnec-

tion of the appliance from the mains with a contact opening of at least

3 mm at all poles. Suitable devices include circuit breakers, fuses

(threaded fuses must be entirely removed from the socket), ground

fault circuit interrupters and contactors. Permanent connection may

only be carried out by an authorised electrician.

;

This appliance conforms to the following EC directives

– "Low-Voltage Directive" 73/23/EWG dated 19 February 1973

and Directive amendment 93/68/EWG

– "EMC Directive" 89/336/EWG dated 3 May 1989

and Directive amendment 93/68/EWG

Water Connection

Your washing machine is fitted with safety devices that prevent drink-

ing water contamination and comply with the regulations of the water

authorities in your country (e.g. in Germany: DVGW Directives). It is

therefore not necessary to take further protective measures in the

installation.

Permissible water pressure

Water pressure must be equal to a least 1 bar (= 10N/cm

= 0.1 MPa),

and no more than 10 bar (= 100N/cm

= 1 MPa).

• By more than 10 bar: connect a pressure reduction valve upstream.

• By less than 1 bar: Unscrew the flexible inlet tubing on the magnetic

inlet valve on one side of the appliance and remove the flow meter

(thereby remove the sieve by means of a pair of pointed pliers and

then remove the rubber washer behind it). Remount the sieve.