User Manual

Operating Instructions

Washing cycle complete/Removing the washing

Once the washing programme has come to an end, END illuminates on

the programme progress display.

• If the EASY IRON programme was selected, an anti-creasing phase of

approximately 30 minutes follows the programme end. Here, the

multi-display still shows a remaining time and the END indicator

lights up. During the anti-creasing phase, you can open the door at

any time and remove the washing.

• If RINSE HOLD was selected, the display beside the START/PAUSE

button flashes.

0 1. After a rinse hold, the water must first be pumped out:

– Either press the START/PAUSE button (the water is pumped out and

the washing is spun according to the completed programme; with the

spin speed/RINSE HOLD button, it is possible to change the spin speed

during spinning),

– turn the programme selector to PUMP OUT and press the START/

PAUSE button (the water is pumped out without spinning),

– turn the programme selector to SPIN or GENTLE SPIN and press the

START/PAUSE button (the water is pumped out and the washing is

spun or gently spun).

At the end of this programme step, the END TIME indicator will

illuminate.

2. Open the door.

As soon as the indicator next to the DOOR/LIGHT button lights up

green, the door can be opened (not if Programme protection is acti-

vated, for details see "Programme protection“).

3. Remove the washing.

4. Turn the programme selector to OFF.

5. After washing, pull out the washing detergent drawer slightly so that it

can dry out. Leave the door ajar so that air can circulate in the drum.

If the OVERDOSING indicator illuminates, then too much

detergent was used in the washing programme just

completed. Observe the dosing recommendations of the

detergent manufacturer as well as the load quantity for the next wash.

Important: If the washing machine is not to be used for a long period:

Close the water tap and disconnect the washing machine from the

electricity mains. (Anti-flood: The Aqua Control with Aqua Alarm does

not function if the power supply is interrupted).