Operation Manual

Installation and Connection Instructions

Water Drainage

The appliance drain hose should hook into a standpipe, the hook in the

drain hose is formed using the plastic U-Piece supplied. The standpipe

should have an internal diameter of approximately 38 mm (see dia-

gram) thus ensuring there is an air break between the drain hose and

standpipe.

When discharging into a stand-

pipe ensure that the top of the

curve in the hose end is no more

than 90 cm (35.4) and no less

than 60 cm (23.6) above floor

level.

The upright standpipe should

have a minimum, length of

30 cm (12) from the bottom of

the elbow to the top of the pipe

(see diagram). Make sure that it

is designed in such a way that

the end of the drain hose can-

not be covered with water.

Longer drain hoses are availa-

ble in lengths of 2.7 and 4

metres from your AEG Service

Force Centre.

If you intend the drain hose

from the washing machine to

empty into a sink, make sure

that the sink is empty and the

plug hose is not blocked. Use

the plastic U-Piece supplied.

Min 60 cm (23,6)

Max 90 cm (35,4)

Min 30 cm (12)

38mm (1

)

diameter standpipe