Operation Manual

Installation and Connection Instructions
44
Installation-Site Preparation
 The installation surface must be clean, dry and level.
 Do not install on deep pile carpet.
 If the appliance is installed next to heat source (e. g. cooking appli-
ance), a heat insulating pad (85 x 57 cm) must be placed between the
washing machine and the heat source.
 Do not install the appliance in locations where the temperature may
fall below freezing.
 Please ensure that when the appliance is installed it is easily accessi-
ble for the engineer in the event of a breakdown.
Installation on a Suspended Floor
Suspended wooden floors are particularly susceptible to vibration. To
help prevent vibration we recommend you place a waterproof wood
panel, at least 15 mm thick under the appliance, secured to at least 2
floor beams with screws. If possible install the appliance in one of the
corners of the room, where the floor is more stable.
Levelling the Appliance
3
Self adjusting foot:
The back right foot of your washing machine is
designed like a spring leg. This makes the machine very stable even at
high spin speeds.
If the washing machine is not stable proceed as follows:
0
1.
Set the three adjustable feet to length of 10 mm. Use the supplied
spanner.
If the self adjusting foot does not reach to the floor:
2.
Manually extend the self adjusting foot to the required length.
3.
Check the appliance is level using a spirit level.
Important!
Never use strips or shims of wood or cardboard etc. to
compensate for any uneveness in the floor. Always use the adjustable
feet.