User manual

Instructions for use
36
Water runs out under
the washing machine.
The screw connection on the
intake hose is leaky.
Tighten the intake hose
screw connection.
The drainage hose is leaky.
Check the drainage hose and
replace it if necessary.
The washing solution pump
cover is not correctly closed.
Close cover correctly.
Washing stuck in the filling
door.
Stop the program, remove
washing from the filling
door, start a new program.
The emergency drain hose is
not properly shut off or it is
not water-tight.
Shut the emergency drain
hose off properly (see section
"Performing an Emergency
Drain"). Call your after-sales
service if the emergency
drain hose is not water-tight.
Fault code EF0
appears.
The Aqua Control anti-flood
system has been activated.
Turn off the tap, then
remove the plug from the
mains and inform Customer
Service.
The drain pump for the
washing machine runs
constantly - even when
the appliance is
switched off.
Conditioner not added,
compartment æ for
care agent full of
water.
Softener insert in the com-
partment for care agent not
correctly attached or is
blocked.
Clean the detergent drawer
and firmly attach the soft-
ener insert.
Washing heavily
creased.
Too mush washing probably
put in.
Pay attention to the maxi-
mum filling quantity (see
Program Tables). For easy-
care textiles, select the pro-
gram EASY IRON
(LEICHTBÜGELN, FACILE A
REPASSER).
The washing has not
been spun as dry as
usual.
The washing was not able to
be distributed evenly in the
drum prior to spinning.
Always load the drum as ful
as possible with a
combination of large and
small items.
Problem Possible Cause Remedy