User manual

Instructions for use

Wash Programme Progress

Programme progress display

Before the wash starts, the steps to be carried out are

displayed by the programme progress display. During

the wash programme the current stage of the pro-

gramme is displayed.

Multi-display

The remaining wash time (in minutes) is

displayed in the multi-display until the

programme has finished.

The remaining wash time may increase or remain stationary during the

wash cycle because the wash programme adjusts itself to the various

conditions as the wash sequence progresses (e.g. type and quantity of

washing, identification of imbalance during spin cycle, special rinse

etc.).

MOISTURE%/LOADING% display

(RESTFEUCHTE%/BELADUNG%)

The following appear alternately in the

display:

• The expected residual moisture in the wash-

ing at the end of the programme. This values

depends on the spin speed set.

• The load in the drum (in graduations of 10 percent).

This value is only displayed for the COTTONS/LINEN, EASY-CARES

(KOCH/BUNT, PFLEGELEICHT) programme.

The washing machine cannot recognise the load until about ten min-

utes after a programme has started. As soon as a value for the load is

available the display alternates between residual moisture and load-

ing. If the drum is too heavily loaded this is displayed with a value

of 120 (percent).

Due to the differences in fabric type and load, the remaining moisture

value is lower for EASY IRON (LEICHTBÜGELN) and DELICATES

(FEINWÄSCHE) than for COTTONS/LINEN, EASY-CARES (KOCH/BUNT,

PFLEGELEICHT) (cotton).

Changing the Spin Speed

The spin speed can still be changed during the wash programme, or

rinse hold (display 0) can be set. Other settings cannot be changed.