User manual

Operating Instructions
35
The drain pump for the
washing machine runs
constantly - even when
the appliance is
switched off.
The Aqua Control anti-flood
system has been activated.
Turn off the tap, then re-
move the plug from the
mains and inform Customer
Service.
Conditioner was not
washed in, compart-
ment æ for care
agents is filled with
water.
Conditioner insert in the
compartment is not correctly
attached or is blocked.
Clean the detergent drawer,
attach the conditioner insert
securely.
Washing heavily
creased
Too mush washing probably
put in.
Pay attention to the maxi-
mum filling quantity (see
Program tables). In the case
of easy-care textiles, select
the program < (EASY
IRON).
Washing is not well
spun. Residual water is
still visible in the drum.
Fault code
(2 appears.
Drainage hose bent. Remove the bend.
Maximum pump head (drain-
age height 1m from the floor
under the unit) is exceeded.
Contact your customer serv-
ice. For pumping heights
over lm he can offer you a
conversion kit as a special
accessory.
Solution pump blocked.
Switch off the unit and pull
out the mains plug. Clean
the solution pump.
If a siphon is connected: Si-
phon blocked.
Clean the siphon.
The door cannot be
opened when the unit
is switched on.
Door locked for safety re-
asons (display
K
/W (DOOR/
LIGHT) not illuminated from
behind).
Wait until
K
/W (DOOR/
LIGHT) is illuminated green
from behind.
The program saving function
is set.
Cancel the program saving
function (see "Program Sav-
ing").
The washing machine is in
Stand-by mode.
Press the button
K
/W
(DOOR/LIGHT) again.
Problem Possible Cause Remedy