User manual

Instructions for use
44
3. While RINSE+ (SPOELEN+, RINCAGE+) lights up constantly, release the
button SOAKING (INWEKEN, TREMPAGE).
After RINSE
+ (SPOELEN+, RINCAGE+) has stopped lighting up, the ad-
ditional rinse is cancelled.
3
An additional rinse increases water consumption and the program run
time.
Solution Cooling
It may be necessary to cool down the washing solution before pumping
off in order to avoid thermal damage to plastic drainage pipes.
3
The washing solution is cooled down at the end of the main washing
cycle before pumping off (by incoming cold water).
(This setting is only effective for COTTONS/LINEN (WITTE/BONTE WAS,
BLANC/COULEURS) at temperatures of over 40 °C.)
No solution cooling is set when the unit is delivered.
Set the Solution Cooling:
0 1. Turn the program selector to SHORT SPIN (KORT CENTRIFUG., ESSOR.
DELICAT).
2. Keep the button PRE WASH (VOORWAS, PRELAV.) pressed for at least
5 seconds.
After the button has been pressed for 5 seconds, MAIN WASH (HOOFD-
WAS, LAVAGE) flashes on the program sequence display for 5 seconds.
3. While MAIN WASH (HOOFDWAS, LAVAGE) is flashing, release the but-
ton PRE WASH (VOORWAS, PRELAV.).
After the flashing has stopped, the solution cooling is set. It is set until
it is cancelled again.
4. If you want to check whether the solution cooling is set:
– Turn the program selector to SHORT SPIN (KORT CENTRIFUG., ESSOR.
DELICAT).
– Briefly press the button PRE WASH (VOORWAS, PRELAV.).
If MAIN WASH (HOOFDWAS, LAVAGE) flashes on the program sequence
display, the solution cooling is set.