User manual

Operating Instructions
21
Set the Delay Timer/Soaking Duration
Delay Timer
The button DELAY TIMER allows the start of a washing program to be
advanced by 1 to a maximum of 19 hours.
0 To do this, press the button DELAY TIMER as
often as necessary until the required start de-
lay is shown in the multidisplay, e.g.12h in the
form for a program start delay of 12 hours.
If19h is shown and you press again, 0h and af-
terwards the run time of the set washing
program appears (display in minutes, e.g.126).
In this state, the delay timer is not set.
3
Once the delay timer has been set, it will only be activated after press-
ing the START/PAUSE button.
Soaking Duration
With the SOAKING button pressed, you can extend the soaking dura-
tion with the button DELAY TIMER (maximum 10 hours and approx.
20 min.).
3
Without delay timer, the soaking duration is approx. 30 minutes, plus a
pre-wash time of approx. 20 minutes.
0 To set, press the button DELAY TIMER as often as necessary until the re-
quired soaking duration is shown in the multidisplay, e.g.1h
(= 1 hour).
After approx. 2 seconds, the multidisplay shows
the run time in minutes.
This run time is comprised as follows:
3
While SOAKING is running, PRE WASH lights up on the program se-
quence display.
selected soaking period e.g. – 1h =60 minutes
+ heating up/prewash period e.g. approx. 20 minutes
+ run time of the selected washing program e.g. approx. 126 minutes
=
displayed value e.g. approx. 206 minutes