User manual

Instructions for use
36
If the washing result is not satisfactory
If the washing is grey and limescale forms in the drum
• Not enough washing detergent added.
• The right washing detergent was not used.
• Special types of stain were not pretreated.
• Program or temperature incorrectly set.
• If binary wahing detergents were used, the individual components
were not added in the correct ratio.
If there are still grey stains on the washing
• Washing contaminated with creams, grease or oils was washing with
too little detergent.
• Washing at too low temperature.
• A frequent cause is that conditioner – particularly concentrated
form, ended up on the washing. Wash out such stains as quickly as
possible and carefully use the right conditioner.
If foam is still visible after the final rinse
• Modern washing detergents can still produce foam, even in the final
rinse. The washing is still sufficiently rinsed.
If there are white residues on the washing
• These are the insoluble components of modern detergents.
They are not the result of an insufficient rinsing effect.
Shake or brush off the washing. Perhaps in future you should turn
the washing before washing it. Check the choice of detergent and use
a liquid detergent if necessary.