User manual

Installation and Connection Instructions

Special spanner H and cover caps E (2 off) and G (1 off) are supplied

with the appliance.

0 1. Remove flexible tubing holder A.

2. Remove the two screws B with special spanner H.

3. Remove the four screws C.

4. Detach transportation rail D.

5. Close the two large openings with the cover caps E.

Attention! Press cover caps forcefully in, so that they snap into the

rear wall (protecting the interior of the appliance against sprayed

water).

6. Drive in the screws C into the four small holes again.

7. Remove the screw and compression spring F with special spanner H,

cover the hole with caps G.

Attention! Press cover caps forcefully in, so that they snap into the

rear wall (protecting the interior of the appliance against sprayed

water).

Prepare the installation place

• The installation surface must be clean and dry, free of floor wax and

other smearing substances, so that the appliance does not slip off. Do

not use any lubricant as sliding aid.

• Installation on a high-veil carpet or floor tiles with soft sponge backs

is not recommended because the standing safety of the appliance is

then no longer ensured.

• By installation surfaces with small-format tiles, lay a conventional

rubber mat underneath.

• Small unevenness of the floor surface should never be levelled out by

laying pieces of wood, carton or similar elements, but rather basically

compensated by adjusting the screw feet.

• When it is unavoidable to install the appliance besides a gas or a

coal-fuelled cooker, due to spatial reasons: insert a piece of heat-

insulating board (85 x 57 cm) between the cooker and the washing

machine; the board side facing the cooker must be provided with an

aluminium foil.

• The washing machine may not be installed in a frost-endangered

room. Frost-caused damages!

• Flexible feed and drain tubings may not be crinkled or squeezed.