User manual

Operating instructions
36
Disabling the additional rinse function:
0 1. Turn the program selector to SHORT SPIN.
2. Press the SOAKING button for at least 5 seconds.
As soon as the button is pressed RINSE
+ flashes on the program
progress display. After 5 seconds RINSE
+ ceases to flash and illumi-
nates continuously for a further 5 seconds.
3. Release the SOAKING button whilst RINSE
+ is continuously illumi-
nated.
Once RINSE
+ has ceased to be illuminated, the additional rinse func-
tion is disabled.
Water Cooling
3
The water is cooled prior to pumping out at the end of the main wash-
ing cycle (by adding cold water). (This setting is only effective for
COTTONS/LINEN at a temperature of over 40 °C.)
As supplied from the factory, the water cooling function is not enabled.
Enabling the water cooling function:
0 1. Turn the program selector to SHORT SPIN.
2. Press the PRE WASH button for at least 5 seconds.
After the button has been kept pressed for 5 seconds, MAINWASH
flashes on the program progress indicator for 5 seconds.
3. Release the PRE WASH button while MAINWASH is flashing.
Once the indicator has stopped flashing, the water cooling function is
enabled. It continues to be enables until specifically disabled.
4. If you wish to check whether the water cooling function is enabled:
– Turn the program selector to SHORT SPIN.
– Press the PRE WASH button briefly.
If the MAINWASH indicator on the program progress display flashes,
the water cooling function is enabled.