User manual

Instructions for use

Starting a wash programme

0 1. Check that the tap is turned on.

2. To start a wash programme: Press the button

START/PAUSE (START/PAUZE, MARCHE/PAUSE).

The programme is started, or will start auto-

matically after the delay timer set has counted down.

The door is not shut properly if, after having pressed the START/PAUSE

(START/PAUZE, MARCHE/PAUSE) button,

– the DOOR (DEUR, PORTE) light flashes red,

– the error code E40 is flashing in the multi-display,

– and the END (EINDE/FIN) light flashes 4 times.

In such an event, firmly press the door shut and press the START/PAUSE

(START/PAUZE, MARCHE/PAUSE) button again.

If the delay timer has been set

The time delay set begins to run down and in the multi-display is dis-

played the time remaining until the start of the programme (in min-

utes, e.g. 30‘, or in hours, e. g. 5h). During this time you can change or

cancel the delay timer:

0 Continue pressing the DELAY TIMER (STARTTIJDKEUZE, DEPART DIFFERE)

button until the desired time is displayed; when the programme dura-

tion is displayed (display in minutes, e.g.126) the wash programme will

start straight away.

Adding washing

Washing can be added, as long as the DOOR (DEUR, PORTE) light is lit in

green:

0 1. Press the START/PAUSE (START/PAUZE, MARCHE/PAUSE) button. The

door can be opened.

2. Close the door and press the START/PAUSE (START/PAUZE, MARCHE/

PAUSE) button again. The programme is resumed.

Completion of the Washing Program

Program Sequence Display

Before the start, the program steps to be carried out are

displayed by the program sequence display. Ther current

program step is displayed during the washing program.