User manual

Water Drainage

The appliance drain hose should hook into a standpipe, the hook in the

drain hose is formed using the plastic “U-Piece“ supplied. The standpipe

should have an internal diameter of approximately 38 mm (see dia-

gram) thus ensuring there is an air break between the drain hose and

standpipe.

Important! It is essential to lay the drainage hose without kinks.

When discharging into a stand-

pipe ensure that the top of the

curve in the hose end is no more

than 90 cm (35.4’’) and no less

than 60 cm (23.6’’) above floor

level.

The upright standpipe should

have a minimum, length of 30 cm

(12’’) from the bottom of the el-

bow to the top of the pipe (see

diagram). Make sure that it is de-

signed in such a way that the end

of the drain hose cannot be cov-

ered with water.

Longer drain hoses are available

in lengths of 2.7 and 4 metres

from your Service Force Centre.

For drainage into an outlet

spigot: If the outlet spigot has not

been used before, remove any blank-

ing plug that may be in place. Push

the drain hose onto the spigot and

secure with a clip if required. Ensure

the drain hose is looped upwards to

prevent waste water from the sink

entering the washing machine.

Important! The end of the drainage hose must not be submerged in the

pumped-out water. Otherwise, the water could be sucked back into the

appliance.