User manual

Installation and Connection Instructions
43
Levelling on uneven floors
Using the four adjustable threaded feet, compensation can be made for
unevenness in the floor and the height of the appliance adjusted. The
height can be adjusted over the range +10... -5 mm.
To adjust the feet use the special spanner supplied for removing the
transport braces.
0 1. Slide the special key firmly onto the hexagon head of the threaded foot
all the way to the stop.
2. Adjust the threaded feet so that the appliance is level and sits stably.
The appliance must not rock across the corners when operating under
load.
3. If necessary, check positioning with a spirit level.
Important! Never compensate for small areas of unevenness in the
floor through the use of wooden wedges, cardboard or the like. Level-
ling should only ever be performed by adjusting the feet.