User manual

3.5 The inlet hose

• Connect the hose to the back appliance.

Turn the inlet hose only left or right.

• Loose the ring nut to set it in the correct

position.

• Connect the water inlet hose to the cold

water tap with 3/4" thread.

CAUTION!

Make sure that there are no

leaks from the couplings.

Do not use an extension hose if the inlet hose is too short. Contact the

service centre for the replacement of the inlet hose.

3.6 Water-stop device

The inlet hose has a water stop device. This

device prevents water leaks in the hose

because of its natural ageing.

The red sector in the window «A» shows this

fault.

If this occur, close the water tap and contact

the service centre to replace the hose.

3.7 Water drainage

There are different procedures to connect the drain hose:

With the plastic hose guide.