User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. INSTALLATION
- 4. PRODUCT DESCRIPTION
- 5. CONTROL PANEL
- 6. DIAL AND BUTTONS
- 7. PROGRAMMES
- 8. BEFORE FIRST USE
- 9. SETTINGS
- 10. DAILY USE
- 10.1 Activating the appliance
- 10.2 Loading the laundry
- 10.3 Filling the detergent and additives
- 10.4 Check the position of the flap
- 10.5 Setting a programme
- 10.6 Starting a programme
- 10.7 Starting a programme with the delay start
- 10.8 The ProSense load detection
- 10.9 Programme phase indicators
- 10.10 Interrupting a programme and changing the options
- 10.11 Cancelling a running programme
- 10.12 Opening the door - Adding garments
- 10.13 End of the programme
- 10.14 Draining water out after end of cycle
- 10.15 Stand-by option
- 11. DAILY USE - WASHING & DRYING
- 12. DAILY USE - DRYING ONLY
- 13. FLUFF IN THE FABRICS
- 14. HINTS AND TIPS
- 15. CARE AND CLEANING
- 16. TROUBLESHOOTING
- 17. CONSUMPTION VALUES
- 18. TECHNICAL DATA
- 19. ACCESSORIES
To clean the water inlet filters:
1
2
3
• Close the water tap.
• Remove the water inlet hose from the
water tap.
• Clean the filter in the inlet hose with a stiff
brush.
• Remove the inlet hose behind the
appliance.
• Clean the filter in the valve with a stiff
brush or a towel.
45°
20°
• Install again the inlet hose. Make sure that
the couplings are tight to prevent
leakages.
• Open the water tap.
15.10 Emergency drain
If the appliance cannot drain the water,
carry out the same procedure, described
in 'Cleaning the drain pump' paragraph.
If necessary, clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
ENGLISH 41