User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. INSTALLATION
- 4. PRODUCT DESCRIPTION
- 5. CONTROL PANEL
- 6. KNOB AND BUTTONS
- 7. PROGRAMMES
- 8. BEFORE FIRST USE
- 9. SETTINGS
- 10. DAILY USE
- 10.1 Using weight sensors
- 10.2 Before activating the appliance
- 10.3 Activating the appliance and setting a programme
- 10.4 Loading the laundry
- 10.5 Filling the detergent and additives
- 10.6 Check the position of the flap
- 10.7 Starting a programme
- 10.8 Starting a programme with the delay start
- 10.9 The ProSense load detection
- 10.10 Programme phase indicators
- 10.11 Interrupting a programme and changing the options
- 10.12 Cancelling a running programme
- 10.13 Opening the door
- 10.14 End of the programme
- 10.15 Draining water out after end of cycle
- 10.16 Stand-by option
- 11. HINTS AND TIPS
- 12. CARE AND CLEANING
- 13. TROUBLESHOOTING
- 14. CONSUMPTION VALUES
- 15. TECHNICAL DATA
- 16. ACCESSORIES
Problem Possible solution
Make sure that the packaging and/or the transit bolts are re-
moved. Refer to 'Installation'.
Add more laundry in the drum. The load may be too small.
The programme duration
increases or decreases
during programme exe-
cution.
The ProSense function is able to adjust the programme dura-
tion according to the type and the amount of the laundry. Re-
fer to 'The ProSense load detection' in 'Daily Use' chapter.
The washing results are
not satisfactory.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you
wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Too much foam in the
drum during the washing
cycle.
Reduce the quantity of detergent.
After the washing cycle,
there are some deter-
gent residues in the dis-
penser drawer.
Make sure that the flap is in the correct position (UP for pow-
der detergent - DOWN for liquid detergent).
Make sure you have used the detergent dispenser according
the indications given in this user manual.
The drum is empty and
the display shows there is
some weight in.
Press the On/Off button to deactivate the appliance and acti-
vate it again to set a tare.
The drum is full but the
display shows 0.0 kg.
You loaded the laundry before activating the appliance. Press
the On/Off button to deactivate the appliance.
Empty the drum and follow the necessary steps. (Refer to
'Loading the laundry')
The drum light does not
go on.
Make sure that the LED lamp is not burned. To replace it, con-
tact the Authorised Service Centre.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
13.3 Emergency door opening
In case of power failure or functioning
failure the appliance door remains
locked. The washing programme
continues when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
www.aeg.com34