User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. INSTALLATION
- 4. PRODUCT DESCRIPTION
- 5. CONTROL PANEL
- 6. KNOB AND BUTTONS
- 7. PROGRAMMES
- 8. BEFORE FIRST USE
- 9. SETTINGS
- 10. DAILY USE
- 10.1 Using weight sensors
- 10.2 Before activating the appliance
- 10.3 Activating the appliance and setting a programme
- 10.4 Loading the laundry
- 10.5 Filling the detergent and additives
- 10.6 Check the position of the flap
- 10.7 Starting a programme
- 10.8 Starting a programme with the delay start
- 10.9 The ProSense load detection
- 10.10 Programme phase indicators
- 10.11 Interrupting a programme and changing the options
- 10.12 Cancelling a running programme
- 10.13 Opening the door
- 10.14 End of the programme
- 10.15 Draining water out after end of cycle
- 10.16 Stand-by option
- 11. HINTS AND TIPS
- 12. CARE AND CLEANING
- 13. TROUBLESHOOTING
- 14. CONSUMPTION VALUES
- 15. TECHNICAL DATA
- 16. ACCESSORIES
maximum load on the detergent
package.
If you change the washing
programme after closing the
door, the display could show
to indicate a
possible overload: open the
door and remove a few
garments.
10.5 Filling the detergent and
additives
Compartment for prewash phase
an soak programme.
Compartment for washing phase.
Compartment for liquid additives
(fabric conditioner, starch).
Maximum level for quantity of
liquid additives.
Compartment for stain remover.
Flap for powder or liquid
detergent.
Always follow the
instructions that you find on
the packaging of the
detergent products, but we
recommend that you do not
exceed the maximum
indicated level ( ). This
quantity will however
guarantee the best washing
results.
After a washing cycle, if
necessary, remove any
detergent residue from the
detergent dispenser.
10.6 Check the position of the
flap
1. Pull out the detergent dispenser until
it stops.
2. Press the lever down to remove the
dispenser.
1
2
3. To use powder detergent, turn the
flap up.
4. To use liquid detergent, turn the flap
down.
www.aeg.com
22