User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. INSTALLATION
- 4. PRODUCT DESCRIPTION
- 5. CONTROL PANEL
- 6. DIAL AND BUTTONS
- 7. PROGRAMMES
- 8. BEFORE FIRST USE
- 9. SETTINGS
- 10. DAILY USE
- 10.1 Activating the appliance
- 10.2 Loading the laundry
- 10.3 Filling the detergent and additives
- 10.4 Check the position of the flap
- 10.5 Setting a programme
- 10.6 Starting a programme
- 10.7 Starting a programme with the delay start
- 10.8 The ProSense load detection
- 10.9 Programme phase indicators
- 10.10 Interrupting a programme and changing the options
- 10.11 Cancelling a running programme
- 10.12 Opening the door
- 10.13 End of the programme
- 10.14 Draining water out after end of cycle
- 10.15 Stand-by option
- 11. HINTS AND TIPS
- 12. CARE AND CLEANING
- 13. TROUBLESHOOTING
- 14. CONSUMPTION VALUES
- 15. TECHNICAL DATA
- 16. ACCESSORIES
• The ventilation opening in the base (if applicable)
must not be covered by a carpet, mat, or any floor
covering.
• The appliance must be connected to the water mains
using the new supplied hose sets, or other new hose
sets supplied by the Authorised Service Centre.
• Old hose sets must not be reused.
• If the mains power supply cable is damaged, it must
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
• Before any maintenance operation, deactivate the
appliance and disconnect the mains plug from the
socket.
• Do not use high pressure water sprays and/or steam
to clean the appliance.
• Clean the appliance with a moist cloth. Use only
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
2. SAFETY INSTRUCTIONS
2.1 Installation
• Remove all the packaging and the
transit bolts.
• Keep the transit bolts in a safe place.
If the appliance is to be moved in
future they must be reattached to lock
the drum to prevent internal damage.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Do not install or use a damaged
appliance.
• Follow the installation instruction
supplied with the appliance.
• Do not install or use the appliance
where the temperature can be less
than 0°C or where it is exposed to the
weather.
• The floor area where the appliance is
to be installed must be flat, stable,
heat resistant and clean.
• Make sure that there is air circulation
between the appliance and the floor.
• Do not install the appliance directly
over the floor drain.
• Adjust the feet to have the necessary
space between the appliance and the
flooring.
• Do not install the appliance where the
appliance door cannot be fully
opened.
• Do not put a container to collect
possible water leakage under the
appliance. Contact the Authorised
Service Centre to ensure which
accessories can be used.
2.2 Electrical connection
• The appliance must be earthed.
• Always use a correctly installed
shockproof socket.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Do not use multi-plug adapters and
extension cables.
www.aeg.com
4