User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. CONDITIONS OF USE
- 3. SAFETY INSTRUCTIONS
- 4. PRODUCT DESCRIPTION
- 5. CONTROL PANEL
- 6. PROGRAMMES
- 7. OPTIONS
- 8. SETTINGS
- 9. BEFORE FIRST USE
- 10. DAILY USE
- 10.1 Using weight sensors
- 10.2 Before activating the appliance
- 10.3 Activating the appliance and setting a programme
- 10.4 Loading the laundry
- 10.5 Filling the detergent and additives
- 10.6 Check the position of the flap
- 10.7 Starting the programme without the delay start
- 10.8 Starting a programme with the delay start
- 10.9 Cancelling the delay start
- 10.10 Cycle time recalculation
- 10.11 Cancelling a running programme
- 10.12 Interrupting a programme and changing a option
- 10.13 Opening the door
- 10.14 End of cycle
- 10.15 Draining water out after end of cycle
- 10.16 AUTO OFF option
- 11. HINTS AND TIPS
- 12. CARE AND CLEANING
- 13. TROUBLESHOOTING
- 14. TECHNICAL DATA
Problem Possible solution
The appliance does not
drain the water.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Make sure that the connection of the drain hose is correct.
• Set the drain option if you set a programme without drain
phase.
• Set the drain option if you set an option which ends with
water in the drum.
• Make sure that the drain filter is not clogged. Clean the fil-
ter, if necessary. Refer to 'Care and cleaning'.
• If problem remains please contact the Authorised Service
Centre.
The spin phase does not
operate or the washing
cycle lasts longer than
usually.
• Set the spin option.
• Set the drain option if you set an option which ends with
water in the drum.
• Make sure that the drain filter is not clogged. Clean the fil-
ter, if necessary. Refer to 'Care and cleaning'.
• Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance prob-
lems.
There is water on the
floor.
• Make sure that the couplings of the water hoses are tight
and there is not water leakages.
• Make sure that the water inlet hose and the drain hose have
no damages.
• Make sure you use the correct detergent and the correct
quantity of it.
You cannot open the ap-
pliance door.
• Make sure that the washing programme is finished.
• Set the drain or the spin option if there is water in the drum.
• Do the emergency drain procedure. See "Frost precau-
tions" (in "Care and Cleaning" chapter).
• Make sure that the appliance receives electrical power.
• This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre. If you need to open
the lid, please read carefully "Emergency door opening".
The appliance makes an
unusual noise.
• Make sure the levelling of the appliance is correct. Refer to
'Installation instruction'.
• Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation instruction'.
• Add more laundry in the drum. The load may be too small.
The cycle is shorter than
the time displayed.
• The appliance calculates a new time according to the laun-
dry load. See the ‘Consumption Values’ chapter.
The cycle is longer than
the time displayed.
• An unbalanced laundry load increases the duration time.
This is a normal behaviour of the appliance.
ENGLISH 25