User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. INSTALLATION
- 4. PRODUCT DESCRIPTION
- 5. CONTROL PANEL
- 6. DIAL AND BUTTONS
- 7. PROGRAMMES
- 8. SETTINGS
- 9. BEFORE FIRST USE
- 10. DAILY USE
- 10.1 Activating the appliance
- 10.2 Loading the laundry
- 10.3 Filling the detergent and additives
- 10.4 Check the position of the detergent flap
- 10.5 Setting a programme
- 10.6 Starting a programme
- 10.7 Starting a programme with the delay start
- 10.8 The ProSense System load detection
- 10.9 Interrupting a programme and changing the options
- 10.10 Cancelling a running programme
- 10.11 Opening the door - Adding garments
- 10.12 End of the programme
- 10.13 Draining water out after end of cycle
- 10.14 Stand-by function
- 11. HINTS AND TIPS
- 12. CARE AND CLEANING
- 13. TROUBLESHOOTING
- 14. CONSUMPTION VALUES
- 15. TECHNICAL DATA
- 16. PRODUCT INFORMATION SHEET IN REFERENCE TO E.U. REGULATION 1369/2017
1. Remove the screws of the top cover on the
rear of the appliance and install the anti-
tilting device as shown in the drawing.
~10mm
2. Adjust the anti-tilting device so that the
distance from the counter is 10mm. Loosen
the nut counterclockwise with a 3mm wrench.
Adjust the height and turn the nut clockwise
to fix it.
3.9 Preparation and assembly of the cupboard door
The dimensions of the cupboard door should be:
• width min. 595 - max. 598 mm;
• thickness 16-22 mm.
Factory pre setting
The appliance is originally pre set for the
assembly of a cupboard door opening from
right to left.
The best solution would be to
screw the upper hinge to the
upper hole of the top plate
and the lower hinge to the
lower hole of the bottom
plate.
ENGLISH 13