Quick Guide

THE PROSENSE LOAD DETECTION
After the programme start and before the water
lling, the appliance estimates the laundry amount
in 30 seconds. The
and indicators ash. After
load estimation, the programme duration is updated
accordingly on the display.
If the drum is overloaded, the display shows the
maximum load and
ashes. In this case, for
further 30 seconds it is possible to pause the appliance
and remove a few garments.
If the laundry amount is not reduced, the appliance starts
the washing programme immediately despite the overload
(for more information see the User manual).
ALARM CODES
The display can show alarm codes (refer to the
“Troubleshooting” table in the user manual):
:
The appliance does not ll water properly.
:
The appliance does not drain the water.
:
The appliance door is open or not closed correctly.
:
The anti-ood device is on. Disconnect the
appliance and close the water tap. Contact the
Authorised service centre.
MIX
Maximum load indicator
Maximum laundry indicator, it ashes in case of overloading.
Door lock indicator and child lock indicator
Delay start indicator
This area can shows: the programme duration (e.g. ), the delay time
(e.g. ), the cycle end ( ), and the warning code (e.g. )
Phase indicators:
Washing Rinse
Soft Plus Spin
Anticrease Steam
MIX
OKO-MIX (if available)
Energy saving indicators. appears if selecting a cotton programme
at 40°C or 60°C.
Time save indicator
Spin speed indicator
Rinse Hold indicator and Quiet indicator
Temperature indicator and Cold wash indicator
INTERACTIVE DISPLAY