User manual

• - No communication between

electronic elements of the appliance.

Switch off and switch on again.

• - The anti-flood device is on.

Disconnect the appliance and close

the water tap. Contact the Authorised

Service Centre.

WARNING!

Deactivate the appliance

before you do the checks.

13.2 Possible failures

Problem Possible solution

The programme does

not start.

Make sure that the mains plug is connected to the mains sock-

et.

Make sure that the appliance door is closed.

Make sure that there is not a damaged fuse in the fuse box.

Make sure that the Start/Pause has been pressed.

If the delay start is set, cancel the setting or wait for the end of

countdown.

Deactivate the Child Lock function if it is on.

The appliance does not

fill with water properly.

Make sure that the water tap is open.

Make sure that the pressure of the water supply is not too low.

For this information, contact your local water authority.

Make sure that the water tap is not clogged.

Make sure that the filter of the inlet hose and the filter of the

valve are not clogged. Refer to “Care and cleaning”.

Make sure that the inlet hose has no kinks or bends.

Make sure that the connection of the water inlet hose is cor-

rect.

The appliance does not

fill with water and drain

immediately.

Make sure that the drain hose is in the correct position. The

hose may be too low.

The appliance does not

drain the water.

Make sure that the sink spigot is not clogged.

Make sure that the drain hose has no kinks or bends.

Make sure that the drain filter is not clogged. Clean the filter, if

necessary. Refer to 'Care and cleaning'.

Make sure that the connection of the drain hose is correct.

Set the drain programme if you set a programme without drain

phase.