User manual

Problem Possible solution
Make sure that the filter of the inlet hose and the filter
of the valve are not clogged. Refer to “Care and clean-
ing”.
Make sure that the inlet hose has no kinks or bends.
Make sure that the connection of the water inlet hose
is correct.
The appliance does
not drain the water.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Make sure that the drain filter is not clogged. Clean the
filter, if necessary. Refer to 'Care and cleaning'.
Make sure that the connection of the drain hose is cor-
rect.
Set the drain programme if you set a programme with-
out drain phase.
Set the drain programme if you set an option which
ends with water in the tub.
The spin phase does
not operate or the
washing cycle lasts
longer than usually.
Set the spin programme.
Make sure that the drain filter is not clogged. Clean the
filter, if necessary. Refer to 'Care and cleaning'.
Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance
problems.
There is water on the
floor.
Make sure that the couplings of the water hoses are
tight and there is not water leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the cor-
rect quantity of it.
You cannot open the
appliance door.
Make sure that the appliance receives electrical power.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in
the drum.
This problem may be caused by a failure of the appli-
ance. Contact the Service.
The appliance makes
an unusual noise.
Make sure the levelling of the appliance is correct. Re-
fer to 'Installation'.
Make sure that the packaging and/or the transit bolts
are removed. Refer to 'Installation'.
22
www.aeg.com