User manual

Before starting the new
programme the appliance
drains the water. Make sure
that the detergent is still in
the detergent compartment,
if not fill the detergent
again.
9.12 Opening the door when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the door lock
indicator stays on and
you cannot open the door.
To open the door proceed as follows:
1. Press the button On/Off for some
seconds to deactivate the appliance.
2. Wait for some minutes and then
open carefully the appliance door.
3. Close the appliance door.
4. Activate the appliance and set the
programme again.
9.13 Opening the door when
the delay start is active
While the delay start operates, the
appliance door is locked.
To open the appliance door:
1. Press button Inicio/Pausa.
In the display the door lock indicator
goes off.
2. Open the appliance door.
3. Close the door and press button
Inicio/Pausa.
The delay start continues.
9.14 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display comes on and the door
locked indicator goes off.
The indicator of Inicio/Pausa button goes
off.
1. Press button On/Off to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent
mildew and odours
5. Close the water tap.
9.15 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.
The door lock indicator is on. The
door stays locked.
You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Press the Inicio/Pausa button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator goes
off, you can open the door .
4. Press On/Off some seconds to
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
9.16 AUTO Stand-by option
The AUTO Stand-by option automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you press Inicio/Pausa
button.
Press the button On/Off to activate
the appliance again.
ENGLISH
13