User manual

ManualsBrandsAEG ManualsDomestic AppliancesL14500VI

The upright standpipe should have a mini-

mum length of 30 cm (12”) from the bottom

of the elbow to the top of the pipe (see dia-

gram). Make sure that it is designed in such a

way that the end of the drain hose cannot be

covered with water.

If you intend the drain hose from the machine

to empty into a sink, make sure that the sink

is empty and the plug hole is not blocked. Use

the plastic “U -Piece” supplied.

Important

Before connecting up the machine to new pipework or to pipework that has

not been used for some time, run off a reasonable amount of water to flush

out any debris that may have collected in the pipes.

In the interest of the environment

Washing machines and dish-

washers should be connected

to the FOUL drainage system,

the water will then be taken

to a sewage works for treat-

ment before being discharged

safely into a river.

It is essential that these appli-

ances are not connected to the

surface water drainage system

as this water is discharged

directly into a river or stream

and may cause pollution.

If you require any further

advice please contact your local

water authority.

Installation

Min. 30 cm.(12")

38 mm.(1/ ") diameter

standpipe

SHOWER

BATH

SINK

TOILET

BIDET

WASHING

MACHINE

DISHWASHER

RAINWATER

'RUN-OFF'

SURFACE WATER

DRAINS & SEWERS

UNTREATED

DISCHARGE

RIVER

FOUL DRAIN

FOUL SEWERS

SEWAGE

TREATMENT

WORKS