Cooktop User Manual

– Remove after the appliance is sufficiently cool: limescale rings , water rings,
fat stains, shiny metallic discolorations. Use a special cleaning agent for glass ce-
ramic or stainless steel.
2. Clean the appliance with a moist cloth and some detergent.
3. At the end rub the appliance dry with a clean cloth.
WHAT TO DO IF...
Problem Possible cause and remedy
You cannot ac-
tivate the appli-
ance or operate
it.
• Activate the appliance again and set the heat setting in 10 seconds.
• You touched 2 or more sensor fields at the same time. Only touch one sen-
sor field.
• The Child Safety Device or the Lock or Stop+Go operates. See the chapter
Operating instruction.
• There is water or fat stains on the control panel. Clean the control panel.
A Sound oper-
ates and the ap-
pliance deacti-
vates.
A sound oper-
ates when the
appliance is de-
activated.
You put something on one or more sensor fields. Remove the object from the
sensor fields.
The residual
heat indicator
does not comes
on.
The cooking zone is not hot because it operated only for a short time. If the
cooking zone should be hot, speak to the service centre.
The Automatic
Heat Up func-
tion does not
operate.
• There is still residual heat on the cooking zone. Let the cooking zone be-
come sufficiently cool.
• The highest heat setting is set. The highest heat setting has the same pow-
er as the Automatic Heat Up function.
You cannot ac-
tivate the outer
ring.
Activate the inner ring first.
The sensor fields
become hot.
The cookware is too large or you out it too near to the controls. Put large
cookware on the rear cooking zones if it is necessary.
There is no sig-
nal when you
touch the panel
sensor fields.
The signals are deactivated. Activate the signals (see OffSound Control).
comes on
The Automatic Switch Off operates. Deactivate the cooking zone and activate
it again after 60 seconds.
If after 60 seconds
comes on again speak to the service centre.
12
What to do if...