User manual

Problem Possible cause Remedy
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Use cookware with diameter
applicable to the activated
function or function mode.
Use cookware with diameter
smaller than 160 mm on a
single section of the flexible
induction cooking area.
Refer to "Flexible induction
cooking area" chapter.
comes on.
Automatic Switch Off oper-
ates.
Deactivate the hob and acti-
vate it again.
comes on.
The Child Safety Device or
the Lock function operates.
Refer to "Daily use" chapter.
comes on.
There is no cookware on the
zone.
Put cookware on the zone.
The cookware is incorrect. Use the correct cookware.
Refer to “Hints and tips”
chapter.
The diameter of the bottom
of the cookware is too small
for the zone.
Use cookware with correct
dimensions.
Refer to “Technical informa-
tion” chapter.
FlexiBridge function oper-
ates. One or more sections
of the function mode which
operates are not covered by
the cookware.
Place the cookware on the
correct number of sections
of the function mode which
operates or change the func-
tion mode.
Refer to "Flexible induction
cooking area" chapter.
PowerSlide function oper-
ates. Two pots are placed on
the flexible induction cook-
ing area.
Use only one pot.
Refer to "Flexible induction
cooking area" chapter.
and a number come on.
There is an error in the hob. Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
www.aeg.com20