User manual

Problem Possible cause Remedy
comes on.
The cooling fan is
blocked.
Check if objects block
the cooling fan. If
comes on again, speak
to the service center.
comes on.
The electrical connection
is incorrect. The appli-
ance is connected only
to one phase.
Connect the appliance
as you see it in the con-
nection illustration.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.
9. INSTALLATION
WARNING!
Refer to the Safety chapters.
Before the installation
Before the installation of the appliance,
record the information below from the
rating plate. The rating plate is on the
bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
9.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into cor-
rect built-in units and work surfaces
that align to the standards.
9.2 Connection cable
• The appliance is supplied with the
connection cable.
• Replace the damaged mains cable
with a special cable (type H05BB-F
Tmax 90°C; or higher). Speak to your
local Service Centre.
9.3 To attach the seal.
• Clean the worktop in the area of the
cut out section.
• Bond the seal stripe supplied on the
lower edge of the appliance along the
outer edge of the glass ceramic. Do
not extend it. Let stay the cut ends in
the middle of one side. When, you cut
it to length (add some mm), push the
two ends together.
ENGLISH 15