User manual

Problem Possible cause Remedy
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
You put something on
one or more sensor
fields.
Remove the object from
the sensor fields.
The appliance deacti-
vates.
You put something on
the sensor field
.
Remove the object from
the sensor field.
The residual heat indica-
tor does not come on.
The cooking zone is not
hot because it operated
only for a short time.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the
service centre.
The Automatic Heat Up
function does not oper-
ate.
The cooking zone is hot. Let the cooking zone be-
come sufficiently cool.
The highest heat setting
is set.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
The heat setting changes
between two levels.
The Power management
is activated.
Refer to “Power man-
agement”.
The sensor fields be-
come hot.
The cookware is too
large or you put it too
near to the controls.
Put large cookware on
the rear cooking zones if
necessary.
There is no signal when
you touch the panel sen-
sor fields.
The signals are deactiva-
ted.
Activate the signals (refer
to “OffSound control”).
comes on
The Automatic Switch
Off operates.
Deactivate the appliance
and activate it again.
comes on
The Child Safety Device
or the Lock function op-
erates.
Refer to the chapter
“Daily Use”.
comes on
No cookware is on the
cooking zone.
Put cookware on the
cooking zone.
Incorrect cookware. Use the correct cook-
ware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
Move cookware to a
smaller cooking zone.
14
www.aeg.com