User manual

Problem Possible cause Remedy
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
You put something on one
or more sensor fields.
Remove the object from the
sensor fields.
The hob deactivates. You put something on the
sensor field .
Remove the object from the
sensor field.
Residual heat indicator does
not come on.
The zone is not hot because
it operated only for a short
time.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Hob²Hood function does not
work.
You covered the control
panel.
Remove the object from the
control panel.
Automatic Heat Up function
does not operate.
The zone is hot. Let the zone become suffi-
ciently cool.
The highest heat setting is
set.
The highest heat setting has
the same power as the func-
tion.
The heat setting changes
between two levels.
Power management function
operates.
Refer to "Daily use" chapter.
The sensor fields become
hot.
The cookware is too large or
you put it too near to the
controls.
Put large cookware on the
rear zones if possible.
There is no signal when you
touch the panel sensor
fields.
The signals are deactivated. Activate the signals.
Refer to "Daily use" chapter.
The flexible induction cook-
ing area does not heat up
the cookware.
The cookware is in the
wrong position on the flexi-
ble induction cooking area.
Place the cookware in the
correct position on the flexi-
ble induction cooking area.
The position of the cook-
ware depends on the activa-
ted function or function
mode.
Refer to "Flexible induction
cooking area" chapter.
ENGLISH 21