User manual

Water hardness
German de-
grees (°dH)
French degrees
(°fH)
mmol/l Clarke de-
grees
Water softener lev-
el
47 - 50 84 - 90 8.4 - 9.0 58 - 63 10
43 - 46 76 - 83 7.6 - 8.3 53 - 57 9
37 - 42 65 - 75 6.5 - 7.5 46 - 52 8
29 - 36 51 - 64 5.1 - 6.4 36 - 45 7
23 - 28 40 - 50 4.0 - 5.0 28 - 35 6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
5
1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 2
<4 <7 <0.7 < 5
1
2)
1)
Factory setting.
2)
Do not use salt at this level.
If you use multi-tablets containing salt
and the hardness of your water is lower
than 21°dH, you can set the lowest water
softener level. It deactivates the salt refill
indicator.
If you use standard detergent or multi-
tablets without salt, set the proper
water hardness level to keep the salt
refill indicator active.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
,
and start to flash
and the display is blank.
2. Press Program.
• The indicators
and
go off.
• The indicator
continues to
flash.
• The display shows the current
setting: e.g.
= level 5.
3. Press Program again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
You can set the released quantity of rinse
aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
will deactivate the rinse aid dispenser
and no rinse aid will be released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators ,
and start to flash
and the display is blank.
2. Press Delay.
www.aeg.com
10