User manual

only, it is possible to deactivate the
notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
and until
the indicators , , , and
start flashing and the display is
blank.
2. Press .
The indicators
, , and
are off.
The indicator still flashes.
The display shows the current
setting: = the rinse aid empty
notification is activated (factory
setting).
3. Press
to change the setting.
= the rinse aid empty notification is
deactivated.
4. Press on/off to confirm the setting.
6.5 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and
hold simultaneously
and until
the indicators , , , and
flash and the display is blank.
2. Press
The indicators , , and
are off.
The indicator still flashes.
The display shows the current
setting: = Acoustic signal off.
3. Press
to change the setting.
= Acoustic signal on.
4. Press on/off to confirm the setting.
6.6 AirDry
AirDry improves the drying results with
less energy consumption.
While the drying phase
operates, a device opens the
appliance door. The door is
then kept ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
open. This can cause
damage to the appliance.
CAUTION!
In case of presence of
children, the AirDry system
can be deactivated if you
want to keep the door
closed in the end of the
cycle.
ENGLISH 11