User manual

5. Remove the flat filter (3) from the

base of the washing compartment

and clean both surfaces thoroughly.

6. Re-insert the flat filter.

7. Place the fine filter in the micro-fil-

ter and fit the two together.

8. Insert the filter system in place and

lock it by turning the handle clock-

wise as far as it will go. Ensure that

the flat filter does not protrude

above the base of the washing com-

partment.

1 Under no circumstances may the dishwasher be used without its filters.

What to do if...

Remedying small malfunctions

If one of the following fault codes is displayed in the multi-display dur-

ing operation:

– Fault codeÅ10 (Problems with water inlet),

– Fault codeÅ20 (Problems with water drainage),

please have a look at the following table.

When the fault is remedied, press the button for the cycle that has

started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

– Abort the dishwashing cycle.

– Switch the appliance off and on again.

– Re-set the dishwashing cycle.

If the fault is displayed again, please contact the Customer Care De-

partment and inform them of the fault code.