User manual

Operating Instructions
34
5. Press the relevant button for the cycle required (see ”Cycle Table”).
The selected cycle will begin after approximately 3 seconds.
The function can no longer be changed after the cycle has begun. In
this case the dishwashing cycle must be aborted by pressing RESET, and
must then be reselected.
3
If the additional function has been selected once, it will remain activa-
ted for all subsequent wash cycles unless it is deactivated by pressing
the button again.
3
The cycles lengths given in the cycle table may change if the additional
function is used.
3
When changing from 3-in-1 dishwashing tablets to conventional
detergent please be sure above all to take note of the last 3 points in
the chapter ”Using 3-in-1 dishwashing tablets”.
Setting or changing the start delay
Using the start delay timer you can adjust when within the next 19
hours the dishwashing cycle is to begin.
Setting the start delay:
0 1. Press the ON/OFF button.
2. Continue pressing the DELAY TIMER button b until the number of
hours’ delay until the dishwashing cycle is to start is flashing in the
multi-display.
3. Press the button for the desired dishwashing cycle.
The length of the selected dishwashing cycle will flash for a moment in
the multi-display, and then it will display the selected starting time
again.
As soon as the number of hours is displayed without flashing, the start
delay has been activated.
The dishwashing cycle will start automatically following a countdown
of the hours set.
Changing the start delay:
As long as the dishwashing cycle has not started, you can still change
the start delay set by pressing the DELAY TIMER button.