User manual

Installation and Connection Instructions

• If the dishwasher is installed under-

neath a kitchen work surface, the

original work surface of the dish-

washer is to be removed as follows:

– Unscrew the screws (1) from the

elbows on the back side.

– Slide the work surface approx.

1cm to the rear (2)

, lift at the

front

(3) and remove.

– Press the work surface retaining

brackets at the position shown in

the diagram

(4) and remove the

bracket at an angle to the rear

(5).

If the dishwasher is later used as a free-standing appliance, the original

work surface must be re-mounted.

The plinth on free-standing appliances is not adjustable.

• Free-standing appliances can be

fitted with a décor panel to match

the facings of other kitchen equip-

ment. The décor panels must be

obtained from the kitchen manu-

facturer. A décor frame is necessary

for installation, and can be

obtained as an accessory from the

dealer if not included in the scope

of delivery.

• Decor panel dimensions:

– Height 590 mm

– Width 581 mm

– Clamp thickness: max. 4 mm

• To ensure that thin decor panels do not flex or distort, attach them to

the door of the appliance using double sided adhesive tape.