User manual

Operating Instructions
33
What to do, when ...
Try to rectify minor faults on the dishwasher with the aid of the
instructions given here. If you call in customer service to resolve one of
the malfunctions listed here, or rectify an error made in the operation
of the appliance, the customer service engineer’s visit is not free of
charge, even during the period of guarantee.
...Error messages are displayed.
If your appliance is equipped with an optical floor signal, in the event
of an error a dot-shaped optical signal will flash on the floor.
3
Errors will only be indicated acoustically if the acoustic signal has been
activated.
If, as listed in the table below, any of the indicators in the control panel
or the display panel are flashing or are illuminated, and/or if an acous-
tic signal can be heard, you can probably rectify the fault yourself.
Malfunction Possible cause Remedy
One continuously repeated
warning tone can be heard;
the cycle indicator for the
selected cycle is flashing:
The
^ indicator is continu-
ously illuminated: Error
code
Å10 is displayed in the
multi-display: There is no
water running into the dish-
washer.
The tap is blocked or
furred with lime-scale.
Clean tap.
The tap is turned off. Turn the tap on.
The filter (where
present) in the
threaded hose fitting at
the water inlet valve is
blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of
the washing compart-
ment are blocked.
Press the button for the
commenced dishwashing
cycle;
then abort the dishwashing
cycle by pressing RESET (see
chapter: Starting a dish-
washing cycle);
Clean out the filters. (See
chapter: Cleaning the filters)
The water inlet hose has
not been correctly laid.
Check hose installation.