User manual

28
What to do if...
Remedying small malfunctions
If one of the following fault codes is displayed in the multi-display dur-
ing operation:
– Fault codeÅ10 (Problems with water inlet),
– Fault codeÅ20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the cycle that has
started. The cycle will continue.
With other fault codes (“Å ” followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact your local Service Force
Centre and inform them of the fault code.
Malfunction Possible cause Remedy
The cycle indicator for the
selected dishwashing cycle
is flashing:
fault code
Å10 is dis-
played in the multi-dis-
play:
(Problems with water in-
let)
Water tap is blocked with
limescale or faulty.
Check the water tap and
have it repaired if necessary.
The tap is turned off. Turn the tap on.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
dishwasher compartment
are blocked.
Cancel the dishwashing cy-
cle (see chapter: Starting a
dishwashing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing
cycle again.
Water inlet hose
has not been correctly posi-
tioned.
Check the position of the
hose.
The cycle indicator for the
selected dishwashing cycle
is flashing,
fault code
Å20 is dis-
played in the multi-dis-
play.
(Problems with water
drainage)
The sink spigot connection
is blocked.
Clean the sink spigot outlet.
Water drain hose
has not been correctly posi-
tioned.
Check the position of the
hose.