User manual

6.6 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and
hold simultaneously and until
the indicators
, , , and
start to flash and the
display is blank.
2. Press
• The indicators , , and
go off.
• The indicator continues to
flash.
• The display shows the current
setting: = Acoustic signal off.
3. Press to change the setting.
= Acoustic signal on.
4. Press the on/off button to confirm
the setting.
6.7 How to set the colour of
the TimeBeam
The appliance must be in programme
selection mode.
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are several colours
available. The TimeBeam can also be
deactivated.
1. To enter the user mode, press and
hold simultaneously
and until
the indicators , , , and
start to flash and the
display is blank.
2. Press .
•
The indicators
, , and
go off.
• The indicator continues
to flash.
• The display shows a number and
the letter C. Each number refers
to a different colour.
–
= TimeBeam
deactivated.
3. Press again and again to
change the colour.
• You can see the different colours
on the kitchen floor.
4. Press the on/off button to confirm
the setting.
7.
OPTIONS
7.1 Options
Desired options must be
activated every time before
you start a programme.
It is not possible to activate
or deactivate options while a
programme is running.
Not all options are
compatible with each other.
If you have selected non
compatible options, the
appliance will automatically
deactivate one or more of
them. Only the indicators of
the options still active will
stay on.
www.aeg.com12