User manual

OPTIONS
Activate or deactivate the options
before the start of a programme.
You cannot activate or deactivate
the options while a programme
operates.
If one or more options are set,
make sure that the related indica-
tors are on before the programme
starts.
ÖKO PLUS
This option decreases the temperature in
the drying phase. The energy consump-
tion decreases by 25%.
The dishes can be wet at the end of the
programme.
Press the ÖKO PLUS button:
• If the option is applicable to the pro-
gramme, the related indicator comes
on.
• If the option is not applicable to the
programme, the related indicator flash-
es for some seconds and then stays off.
MULTITAB
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse
aid and salt. The related indicators are off.
The programme duration can increase.
• Press the multitab button, the related
indicator comes on.
• The option stays on until you deactivate
it. Press the multitab button, the related
indicator goes off.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Deactivate the multitab option.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.
ACOUSTIC SIGNALS
The acoustic signals operate in these con-
ditions:
• The programme is completed.
• The level of the water softener is adjus-
ted electronically.
• The appliance has a malfunction.
Factory setting: on. You can deac-
tivate the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode. Refer to ‘SET-
TING AND STARTING A PRO-
GRAMME’.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4) and (5) flash.
3. Press button (5),
• The indicators of buttons (3) and (4)
go off.
• The indicator of button (5) contin-
ues to flash.
• The display shows the setting of the
acoustic signals.
On
Off
4. Press button (5) to change the setting.
5. Deactivate the appliance to confirm.
10
www.aeg.com