Operation Manual

Problem Possible cause Possible solution
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
The filters are dirty or not as-
sembled and installed correctly.
Make sure that the filters are
clean and correctly assembled
and installed.
The quantity of detergent was
not sufficient or missing.
Make sure that the quantity of
detergent is sufficient.
Limescale particles on the
dishes.
The salt container is empty. Fill the salt container with dish-
washer salt.
Incorrect water softener ad-
justment
Adjust the water softener.
The salt container cap is not
closed correctly.
Make sure that the salt con-
tainer cap is closed correctly.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Rinse aid dosage is too high. Decrease the rinse aid dosage.
Dry water drop stains on
glasses and dishes.
Rinse aid dosage is too low. Increase the rinse aid dosage.
The detergent can be the
cause.
Use a different brand of deter-
gent.
The dishes are wet. You have set a washing pro-
gramme without drying phase
or with a decreased drying
phase.
Let the door stay ajar for some
minutes before you remove the
dishes.
The dishes are wet and dull. The rinse aid dispenser is emp-
ty.
Fill the rinse aid dispenser with
rinse aid.
The multitab function is on
(this function automatically
deactivates the rinse aid dis-
penser).
Activate the rinse aid dispense.
How to activate the rinse aid dispenser
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function buttons A and C go off.
– The indicator light for function button B continues to flash.
What to do if…
23