822_949_344 CG6400.book Seite 1 Mittwoch, 25.
822_949_344 CG6400.book Seite 2 Mittwoch, 25.
822_949_344 CG6400.book Seite 3 Mittwoch, 25.
822_949_344 CG6400.book Seite 4 Mittwoch, 25.
822_949_344 CG6400.book Seite 5 Mittwoch, 25.
822_949_344 CG6400.book Seite 6 Mittwoch, 25.
822_949_344 CG6400.book Seite 33 Mittwoch, 25. Oktober 2006 12:38 12 g Customer g Dear Please read this user manual carefully, paying special attention to the safety notes! Keep the manual in a safe place for later reference, and pass it on to any new owner. Contents 1 Figure captions 34 1.1 Front view (Fig. 1) 34 1.2 Front view with open service door (Fig. 2) 34 1.3 Control panel (Fig.
22_949_344 CG6400.book Seite 34 Mittwoch, 25. Oktober 2006 12:38 12 g 1 1.1 Figure captions 1.2 Front view (Fig. 1) P Drip grid Q Thermos jug R Main switch (rear side of appliance) S Height-adjustable coffee dispenser T Control panel (see Fig. 3) U Bean container lid V Pre-ground coffee lid W Heated cup rack X Swivel pipe for steam and hot water Y Steam nozzle (removable) Z Inner part of steam nozzle (removable) Service door opening button 1.3 Water tank with max.
822_949_344 CG6400.book Seite 35 Mittwoch, 25. Oktober 2006 12:38 12 g 2 Coffee and espresso • • • • • • Your fully automated coffee machine guarantees you absolute ease of operation, both in making coffee and in maintenance and care.
822_949_344 CG6400.book Seite 36 Mittwoch, 25. Oktober 2006 12:38 12 g • Caution! Danger of scalding when the steam nozzle is activated! Hot water or steam output can cause scalding. Activate the steam nozzle only when you are holding a container under the nozzle. • Do not use steam to heat inflammable liquids! • Only use the coffee machine with water in the system! Fill the water tank only with cold water. Do not use hot water, milk or other liquids. Do not exceed the maximum fill level of approx. 1.
822_949_344 CG6400.book Seite 37 Mittwoch, 25. Oktober 2006 12:38 12 g 4 Overview of the menu items • • • • • • • • • 5 Menu mode Below is an overview of those menu items where you can change and save the machine parameters that are preset at the factory, and also start programs and call up information. You will find detailed information on this in the further chapters of these operating • instructions. «CHOOSE LANGUAGE» menu Display language; several languages • are available for selection.
822_949_344 CG6400.book Seite 38 Mittwoch, 25. Oktober 2006 12:38 12 g 6.2 Filling with water 1 Each time before switching on the coffee machine, check that there is water in the water tank, and refill if necessary. The coffee machine requires water for the automatic rinsing processes 3 each time the machine is switched on or off. 0 Remove the water tank from the coffee machine (Fig. 6). Before the tank is removed, the steam nozzle must 6.
822_949_344 CG6400.book Seite 39 Mittwoch, 25. Oktober 2006 12:38 12 g progress bar will be complete and the display shows «TURN STEAM KNOB». 0 Turn the steam knob clockwise (Fig. 10) as far as it will go, to the position , to stop the water running out. The appliance now displays «TURNING OFF PLEASE WAIT...» and switches itself off. 0 Fill the coffee bean container with coffee beans; see „Filling the coffee bean container“, page 38.
822_949_344 CG6400.book Seite 40 Mittwoch, 25. Oktober 2006 12:38 12 g the machine to the water hardness level corresponding to the local water hardness. You can use the enclosed test strip to determine the water hardness, or contact your local water supply company. Determining water hardness 0 Dip the test strip in cold water for around 1 second. Shake off the excess water, and gauge the hardness by means of the pink bands. No pink bands or one pink band: Hardness level 1, soft up to 1.
822_949_344 CG6400.book Seite 41 Mittwoch, 25. Oktober 2006 12:38 12 g gram (Programming the fill level)“, page 48. You can also choose coffee with an extra-mild, mild, normal, strong or extra-strong strength. 0 To choose the required strength, turn the knob for "Coffee strength selection" (Fig 14). The selected coffee strength will be displayed. 0 Place one or two cups under the coffee dispensing spouts (Fig. 15).
822_949_344 CG6400.book Seite 42 Mittwoch, 25. Oktober 2006 12:38 12 g 0 Confirm the menu item with the "OK" key (Fig. 5). The display shows «RINSING», and an advancing progress bar with a percentage indication « 40%». After rinsing, the machine returns automatically to the coffee mode. water from the steam nozzle for a few seconds. 3 7.1 When using the appliance for the first time, at least 4-5 cups of coffee need to be made before the appliance starts to yield satisfactory results.
822_949_344 CG6400.book Seite 43 Mittwoch, 25. Oktober 2006 12:38 12 g press the "JUG“ key (Fig. 19). Once you have done this, the appliance will deliver just the last 2 cups, to reach the programmed quantity of 8 cups. If there is either too little water to complete the requested operation, or the waste coffee container is full, the machine will stop the operation. The jug has to be removed to fill the water tank or to empty the waste coffee container; at this point, the current program is cancelled.
822_949_344 CG6400.book Seite 44 Mittwoch, 25. Oktober 2006 12:38 12 g appliance will not make the coffee, the ground coffee will be dispersed inside the appliance, dirtying it, or the coffee will be delivered drop by drop and the message «GROUND TOO FINE ADJUST MILL AND TURN KNOB» will be displayed. Do not add ground coffee during the brewing process. Only put in ground coffee for the next cup when the brewing process has completely finished and the coffee machine is ready.
822_949_344 CG6400.book Seite 45 Mittwoch, 25. Oktober 2006 12:38 12 g To avoid any residual water mixing in with the milk when frothing, the water should be drained off beforehand. To do this, place a container under the steam nozzle and turn the knob for steam and hot water (Fig. 9) to position until steam emission starts. Then turn the knob back to position . 0 Pour low-fat, cold milk into a mug which must be small enough to fit under the steam nozzle. 3 The milk should be cold.
822_949_344 CG6400.book Seite 46 Mittwoch, 25. Oktober 2006 12:38 12 g 11 Preparing hot water The hot water can be used to pre-heat cups and for making hot drinks, e.g. tea or instant soups. Caution! Danger of scalding when the hot water nozzle is activated! Hot water or steam output can cause scalding. Activate the hot water nozzle only when a container is under the hot water nozzle. 0 Place a container under the hot water nozzle. 0 Turn the knob for steam and hot water to the position (Fig. 10).
822_949_344 CG6400.book Seite 47 Mittwoch, 25. Oktober 2006 12:38 12 g 13.2 Setting the coffee temperature 0 0 0 0 0 There are three temperature levels to choose from. The coffee temperature levels are defined as follows: «TEMPERATURE LOW» «TEMPERATURE MEDIUM» «TEMPERATURE HIGH» The factory setting is «TEMPERATURE HIGH». You can change this setting as follows: Press the "Menu" key (Fig. 4). The menu item «CHOOSE LANGUAGE» appears. Press the scrolling keys "<" or ">" (Fig.
822_949_344 CG6400.book Seite 48 Mittwoch, 25. Oktober 2006 12:38 12 g 0 Press the scrolling keys "<" or ">" (Fig. 5) until the menu item «JUG PROGRAM» appears. 3 0 Confirm the menu item with the "OK" key (Fig. 5). The display indicates «JUG COFFEE TASTE». 0 0 Confirm the menu item with the "OK" key (Fig. 5). The display indicates the current setting, e.g. «EXTRA-MILD JUG». 13.
822_949_344 CG6400.book Seite 49 Mittwoch, 25. Oktober 2006 12:38 12 g If "OK" is not pressed, after about 120 sec. the appliance returns automatically to the coffee mode without storing the setting. After programming, the display returns automatically to the menu item for setting the fill level, e.g. «ESPRESSO CUP». 0 To return to the coffee mode, press the "Menu" key (Fig. 4) twice or wait about 120 sec for the machine to return automatically to the coffee mode.
822_949_344 CG6400.book Seite 50 Mittwoch, 25. Oktober 2006 12:38 12 g 14 Cleaning and Care To ensure consistent coffee quality and faultless operation, always keep your coffee machine clean. 14.1 Regular cleaning 14.2 Emptying the waste coffee container The appliance counts the number of coffees made. Every 14 single coffees (or 7 doubles) the appliance displays the message: «EMPTY WASTE COFFEE CONTAINER» to indicate that the waste coffee container is full and must be emptied and cleaned.
822_949_344 CG6400.book Seite 51 Mittwoch, 25. Oktober 2006 12:38 12 g 0 Remove any remaining coffee beans (you could use the vacuum cleaner with the hose or crevice tool attachment for this). 3 If a foreign object is impossible to remove, contact the Customer Service Centre. Caution! Risk of injury from the moving grinder. Never switch the coffee machine on when you are working on the grinder. This can lead to severe injuries.
822_949_344 CG6400.book Seite 52 Mittwoch, 25. Oktober 2006 12:38 12 g 3 If it is still hard to insert the brewing unit, leave it out of the appliance, close the service door, unplug the appliance from the mains, then plug in again. Wait unitl the display has switched off, then open the service door and replace the brewing unit. 14.5 Running the descaling program The descaling program allows you to descale your coffee machine simply and effectively.
822_949_344 CG6400.book Seite 53 Mittwoch, 25. Oktober 2006 12:38 12 g 0 0 0 0 0 3 appliance. The upper line of the display shows the alternating messages «RINSING» and «TURN STEAM KNOB», whilst the lower line shows a progress bar with the percentage indication « 50%». Empty the container under the steam nozzle and replace it there. Turn the knob for steam and hot water to the position . A rinsing procedure with fresh water is carried out and the rinse water runs out of the steam nozzle.
822_949_344 CG6400.book Seite 54 Mittwoch, 25. Oktober 2006 12:38 12 g «INSERT WASTE COFFEE CONTAINER» • The waste coffee container has probably not been replaced after cleaning. 0 Open the service door and insert the waste coffee container. «ADD PRE-GROUND COFFEE» • With the ground coffee function selected, ground coffee has not been poured into the ground coffee filler. 0 Add the ground coffee as described in chapter „Using pre-ground coffee“, page 43.
822_949_344 CG6400.book Seite 55 Mittwoch, 25. Oktober 2006 12:38 12 g The coffee runs out too quickly • The coffee is ground too coarsely. 0 Turn the knob for setting grinding texture one click anticlockwise (see „Setting the grinding texture“, page 46). 3 The coffee flows out of only one of the dispensers • The dispenser holes are blocked. 0 Scrape off the dry coffee residues with a needle (Fig. 29).
822_949_344 CG6400.book Seite 56 Mittwoch, 25. Oktober 2006 12:38 12 g 0 Remove the brewing unit and thoroughly clean the inside of the appliance, as described in the section „Cleaning the brewing unit“, page 51. Repeat the operation, but switch the appliance on first. • • • • 18 What to do if the coffee machine has to be transported Keep the original packaging as transport protection. It is important to use the original plastic bag as a protection against scratches.
822_949_344 CG6400.book Seite 57 Mittwoch, 25. Oktober 2006 12:38 12 g 20 If service is needed If repairs should become necessary, including replacement of the mains cable, please telephone in the first instance our AEG-Electrolux Service Line. For Germany : 01801 - 20 30 60* (*Local tariff on Deutsche Telekom's landline network) Monday to Friday 8.00 am - 6.00 pm For Austria: For Repairs service: 0810-955 400 * For Product service: 0810-955 200* *From TELEKOM AUSTRIA’s landline network 0.10 Euro/min.
822_949_344 CG6400.book Seite 58 Mittwoch, 25.
822_949_344 CG6400.book Seite 86 Mittwoch, 25.