User manual

5. Press to confirm.
6. Set the temperature.
7. Press to confirm.
6.8 Steam cooking
The water drawer cover is in the control
panel.
WARNING!
Use only cold tap water. Do
not use filtered
(demineralised) or distilled
water. Do not use other
liquids. Do not put
flammable or alcoholic
liquids into the water
drawer.
1. Press the cover of the water drawer
to open it.
2. Fill the water drawer with cold water
to the maximum level (around 950
ml) until the signal sounds or the
display shows the message. Do not
fill the water drawer over its
maximum capacity. There is a risk of
water leakage, overflow and furniture
damages.
3. Push the water drawer to its initial
position.
4. Turn on the appliance.
5. Set a steam heating function and the
temperature.
6. If necessary, set the function:
Duration or: End Time .
The steam appears after
approximately 2 minutes. When the
appliance reaches the set
temperature, the signal sounds.
When the water drawer is running
out of water, the signal sounds and
the water drawer needs to be refilled
to continue the steam cooking as
described above.
The signal sounds at the end of the
cooking time.
7. Turn off the appliance.
8. Empty the water drawer after the
steam cooking is completed.
Refer to the cleaning function: Tank
Emptying.
CAUTION!
The appliance is hot.
There is a risk of burns.
9. After Steam Cooking steam can
condensate on the bottom of the
cavity. Always dry the bottom of the
cavity when the appliance is cool.
Let the appliance dry fully with the door
open. To speed up the drying you can
close the door and heat up the appliance
with function: True Fan Cooking at
temperature 150°C for approximately 15
minutes.
6.9 Heat-up indicator
When you turn on a heating function, the
bar on the display comes on. The bar
shows that the temperature increases.
When temperature is reached the buzzer
sounds 3 times and the bar flashes and
then disappears.
6.10 Fast Heat Up Indicator
This function decreases the heat-up time.
Do not put food in the oven
when the Fast heat up
function works.
To turn on the function, hold for 3
seconds. The heat-up indicator
alternates.
6.11 Residual heat
When you turn off the oven, the display
shows the residual heat. You can use the
heat to keep the food warm.
www.aeg.com
18