User manual

• If the display says that the appliance is in pause, the door can be opened

• If the display says alternately that the appliance is in pause and the door is locked, this

means that the machine is already heating, that the water level is above the bottom

edge of the door or that the drum is turning: in this case the door can not be opened

• If you cannot open the door but you need to open it you have to switch the machine

off by turning the selector dial to

. After about some minutes the door can be

opened (pay attention to the water level and temperature!) .

After closing the door, it is necessary to select the previous programme again and to

press the button 7 , the machine will resume the programme from the point where it

had been interrupted.

At the end of the programme

The machine stops automatically. The pilot light of the button 7 goes off, a static

appears on the display and the acoustic signal sounds for some minutes.

If the RINSE HOLD or NIGHT CYCLE option has been selected, the pilot light of the button

7 goes off, the display says that the door is locked and the RINSE HOLD option has been

selected, the door is blocked to indicate that the water must be emptied out.

Please follow the below instructions to empty out the water:

•

turn the programme selector dial to

/OFF,

•

select the DRAINING or SPINNING programme and confirm it by pressing button 5 ,

• reduce the spin speed if needed, by means of the relevant button,

•

press the button 7 ,

• when the programme has finished the display shows a static

and the display

says that the programme is finished. The door can be opened.

Turn the programme selector dial to

/OFF to switch the machine off. Remove the laun-

dry from the drum and carefully check that the drum is empty.

If you do not intend to carry out another wash, close the water tap. Leave the door open

to prevent the formation of mildew and unpleasant smells.

Stand by : once the programme has finished after a few minutes the energy saving sys-

tem will be enabled. The brightness of the display is reduced. By pressing any button the

appliance will come out of the energy saving status.