User manual

30
The display goes out
while a wash cycle is
running.
Power cut.
For safety reasons, the door
will remain locked for ap-
prox. 4 minutes.
The programme will continue
when the power cut is over.
To remove washing:
If water can be seen in the
appliance, before opening
the door, first perform an
emergency drain.
The background illumi-
nation of the display
has gone out even
though the appliance is
switched on.
The washing machine is in
stand-by mode.
Press any key.
Water is not entering
the appliance. ATTEN-
TION ERROR CODE
(E11)/ PLEASE OPEN
THE WATER TAP ap-
pears in the display.
Tap turned off. Turn on the tap.
The filter in the threaded in-
let hose fitting is blocked.
Turn off the tap. Unscrew the
hose, take out the filter and
clean it.
Water tap is furred with lime
scale or is faulty.
Check the tap and have it re-
paired, if necessary.
The washing has not
been spun thoroughly
and water remains visi-
ble in the drum.
ATTENTION ERROR
CODE (E21)/ PLEASE
CHECK THE WATER
DRAINAGE appears in
the display.
Drain hose is kinked. Remove kink.
Maximum pumping height of
1m exceeded.
Please contact your Local
Service Force.
The drain pump is blocked.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
For sink spigot connections:
The sink spigot is blocked.
Clean the sink spigot.
Problem Possible cause Remedy