User manual

20
The E (END) indicator
flashes 1x.
(Problems with water
inflow)
Tap turned off. Turn on the tap.
The filter in the screw con-
nection on the inlet hose is
blocked.
Turn off the tap. Unscrew the
hose, remove the filter and
clean it.
Water tap is furred with
lime scale or is faulty.
Check the tap and have it re-
paired if necessary.
The washing machine
vibrates when operating
or is not stable.
The transportation lock has
not been removed.
Remove the transportation
lock.
The screw feet are not cor-
rectly adjusted.
Adjust the feet as described
in the installation and con-
nection instructions.
Washing has not been
spun.
Only a few large items of
washing in the drum.
Always load the drum as full
as possible. Mix large and
small items.
Water is running out
from under the washing
machine.
Screw connection on the in-
let hose is leaking.
Screw the inlet hose on
tightly.
Drain hose is leaking. Replace drain hose.
Drain pump cover is not
closed properly.
Close the cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
Emergency drain hose is
leaking.
Close off emergency drain
hose properly.
Wash water is foaming
excessively.
Too much detergent has
probably been used.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
The E (END) indicator
flashes 2x.
(Problems with water
outflow.)
Kink in drain hose. Straighten the hose.
Maximum pumping height
of 1m has been exceeded.
Please contact customer
service.
Drain pump is blocked.
Switch off the appliance. Re-
move the mains plug.
Clean the drain pump. Re-
move any foreign objects
from the pump housing.
For sink spigot connections:
The sink spigot is blocked.
Clean the sink spigot.
Problem Possible cause Remedy