User manual

16
Starting a programme
1. Check that the tap is turned on.
2. Press the S/P (START/PAUSE) button. The programme starts or will
start after the delay timer has elapsed as set.
During the wash programme the current stage of the programme is
shown in the programme progress display.
3 If after pressing the S/P (START/PAUSE) button the E (END) display
flashes 4x, the door has not been closed properly. Push the door firmly
closed and press the S/P (START/PAUSE) button again.
Interrupting a programme/adding washing
Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
S/P (START/PAUSE) button. It is then re-started by pressing the
S/P (START/PAUSE) button again.
• To stop the washing machine before the programme has ended, turn
the programme knob to O (OFF). Important! Be careful if there is
water in the appliance!
Adding washing
It is possible to add washing, as long as the K (DOOR) light is not lit.
1. Press the S/P (START/PAUSE) button. The door can be opened.
2. Shut door and press the S/P (START/PAUSE) button again. The pro-
gramme continues.
End of the wash programme/Removing the washing
When the programme has finished, E (END) will illuminate in the pro-
gramme progress display. As soon as the K (DOOR) indicator has gone
out and the E (END) indicator is illuminated, the door can be opened.
1. Open the door and remove the washing.
2. Turn the programme knob to O (OFF).
3. Turn off the tap.
4. After the machine has finished washing, pull out the detergent drawer
a little to let it dry out. Keep the door very slightly open so that the
washing machine can air.